Salinometer
 |
A temperature compensated salinometer system with in line
retractable probes that will operate up to 10 bar pressure and
140?C.
The AQ500 range of salinometers comprises the following
sub-assemblies which are electrically interconnected
Probe assembly
Probe amplifier module
Display and conditioning board
Optional external alarm
Optional Data Comm Unit with AQUANET software
Data logging together with display and analysis of data are
possible, by connecting to a suitable PC running AQUANET
software . Download
the PDF specifications here |
A single unit has the ability to continuously monitor and
provide alarms up to eight probes whilst maintaining galvanic
isolation between channels, complete with a scrollable LCD
display for local display of each probe reading.
If more than eight probes are required, then additional units
must be installed.
The units are interlinked and only require a mains supply with
the alarm outputs run to the PC, which is placed at the control
station and will give a permanent display of all readings and
Hi/Lo alarm indication. Event alarms provide warning messages
and advise corrective action. There are 4 fully configurable
alarms per probe, which are normally factory set to your
requirements.
Calibration is possible either locally at the probe amplifier,
on the control panel or via AQUANET software to a suitable PC.
If AQUANET software is used then time programmable warnings for
calibration appear at regular intervals and when alarms occur
they can alert through the ships IAS system.
| Controller Dimensions
350 x 350 x 120mm
Operational temperature 0 to 55?C
Storage temperature -15 to 85?C
RH 0-95% non condensing
Input power 110/220VAC 50/60Hz
Power requirement 50 watts
Operational temperature 0 to 55?C
Humidity 0-95% non condensing
Alarm relay contacts 220Vac @ 1 Amp
Terminals suitable for 2.5mm
Amplifier loop and control cable
Armoured screened 6 core 1mm2 for standard amplifiers
max length 100 metres in normal conditions
Optional Siren IP 65 ,
104dB@1m
Optional Beacon Red Flashing IP65
Active whenever alarm condition exists.
|
Probes
Stainless steel sensor housed in Peek body and screwed
into a bronze shaft.
The probe is ac energised and includes temperature
compensation 20?C to 150?C.
The entire assembly fits into a retractable probe
housing allowing servicing and cleaning of the probe
without closing down the line.
Standard ranges 0-25, 0-50, 0-100, 0-120, 0-400
micro Siemens
(other ranges available)
Max pressure 10 Bar
Max Temperature 150?C
Probe Amplifiers
12-24 Vdc internal power rails with 4-20mA output .
Operational temperature 0? to 55?C
|
|
Aquanet